Q14. Load balancing in routing is used to:

Q15. What is the main advantage of using an Overlay Network in a data center?

Q16. Fill in the blank: In BGP, a route received from an ___________ peer will not be advertised to another ___________ peer by default.

Q17. What type of BGP is used for routing within the same autonomous system?

Q18. Which OSPF troubleshooting tool is used to check the OSPF process and neighborship?

Q19. Fill in the blank: In BGP, the ___________ attribute is used to influence the best path selection process.

Q20. What does filter-based forwarding in networking typically allow?

Q21. You are configuring OSPF in your network as shown in the exhibit. R1 has been configured with interface metrics. All other links in the network are using the default interface metric.
In this scenario, which OSPF interface on R1 will be preferred when routing traffic between R1 and R5?

Q22. What is the primary role of an IRB interface in a VLAN configuration?

Q23. What is the first route selection mechanism for IBGP?

Q24. In networking, what is a RIB group primarily used for?

Q25. Which statement is correct about a five-stage IP fabric topology?

Q26. Which two protocols can you use for a data center underlay network? (Choose two)

Q27. In the Junos OS, what is the default behavior of a switch when it receives a frame with an unknown destination MAC address?

Q28. Which of the following are functions of MACsec? (Choose two)