[Q12-Q26] Get 100% Passing Success With True DES-4122 Exam! [Sep-2022]

5/5 - (1 vote)

Get 100% Passing Success With True DES-4122 Exam! [Sep-2022]

EMC DES-4122 PDF Questions – Exceptional Practice To Specialist – Implementation Engineer, PowerEdge Exam

QUESTION 12
A technician installs eight servers into a fully operational rack with top of rack switch Each server has a quad
1Gb NIC and redundant power supplies The company uses iDRAC in shared LOM mode with LOM1 as the selected NIC What should the technician do to verify iDRAC connectivity on each server?

iDRAC Datacenter license is installed.

Ethernet port LOM1 is cabled and the link light is green.

iDRAC dedicated NIC port is cabled and the link light is green

iDRAC Enterprise license is installed

QUESTION 13
A Dell EMC PowerEdge 14G server uses Intel OPTANE DC Persistent Memory in App Direct mode. What is the minimum size DIMM supported for this type of memory?

64 GB

128 GB

256 GB

512 GB

QUESTION 14
How can a technician know whether IDRAC9 System Lockdown mode is enabled?

Lockdown activation message in red box in the iDRAC web GUI Access to LCC is disabled when the server boots

Lockdown activation message in red box in the iDRAC web GUI Access to LCC requires a password when the server boots

Lockdown activation message in yellow box in the iDRAC web GUI Access to LCC is disabled when the server boots

Lockdown activation message in yellow box in the iDRAC web GUI Access to LCC requires a password when the server boots

QUESTION 15
How can the ePSA be accessed?

iDRAC

Lifecycle Controller

VMware vSphere plug-in

OMSA

QUESTION 16
A Dell EMC PowerEdge server logs the following CPU Machine Check error CPU1 IERR What action might solve the problem?

Remove flea power

Update the Intel driver

Reseat the IDSDM

Swap the PERC controller

QUESTION 17
Where is the data stored to allow Easy Restore to successfully complete a system board replacement?

NAND Flash module on the disk drive mid plane

IDSDM SD card

vFlash SD card

Serial Flash storage in the server’s front panel

QUESTION 18
A technician needs to update the IDRAC license on a Dell EMC PowerEdge R740 server from Express to Enterprise. The server has the following components:
* 2x CPUs
* 384 GB RAM
* 6x 1 TB drives
* 1x PSU
The server is connected to active AC, but it is powered down, and it needs to stay powered down No errors are presently displayed How can the technician upgrade the license?

The license cannot be upgraded on a single PSU system

Power on the server, then connect to the iDRAC and upgrade iDRAC license before powering down the server

The license cannot be upgraded because the user will not allow the server to be powered on

Connect to the iDRAC GUI and upgrade the .DRAC license while the server .s powered down

QUESTION 19
You must configure a BOSS card with 2 x 120GB drives for a Dell EMC PowerEdge server. What is the only supported mode?

RAID 0

RAID 5

RAID 1

Non-RAID Mirroring

QUESTION 20
Which card connects to the PCI bus, is physically smaller than a on the system board of a Dell EMC PowerEdge 14G server?

NDC

OCP

PCIe

FPGA

QUESTION 21
A technician is sent on-site to troubleshoot a server that produced an error message during the most recent POST, but then completed the POST and booted to the operating system. The user cannot remember the specific error and no entry was made in the error log relating to this error.
How can the technician find out what the error message was?

Access the Lifecycle Controller and view the last boot cycle video capture entry

Reload the BIOS firmware

Export the Server profile and analyze for any POST errors

Access the iDRAC and view the last boot cycle video capture entry

QUESTION 22
What is the purpose of the Silicon-Based Hardware Root of Trust feature in Dell EMC PowerEdge 14G servers?

Ensures that the installed operating system is authentic

Ensures that the server has a valid Service Tag number

Ensures that no unauthorized BIOS or firmware codes are run

Ensures that the server boots only when connected to a verified network

QUESTION 23
A Dell EMC PowerEdge server has been updated with an LCC and iDRAC DUP to the latest firmware when performing a firmware rollback?

Both the iDRAC and the LCC can be rolled back

The LCC can be rolled back; the iDRAC cannot be rolled back

The iDRAC can be rolled back; the LCC cannot be rolled back

The iDRAC cannot be rolled back and the LCC cannot be rolled back

QUESTION 24
You are creating a new RAID 5 storage pool on a Dell EMC PowerEdge server based on 30 x 1TB drives Which PERC model best supports this configuration?

S140

H740P

H740T

H330

QUESTION 25
What is required for iDRAC Direct 2.0 to connect with IDRAC9 interfaces such as RACADM and WSMAN?

Wi-Fi connection

NFC connection

Ethernet cable

Micro-AB USB

QUESTION 26
An engineer is checking a newly delivered Dell EMC PowerEdge R640 server that will be deployed for a new database environment The inventory consists of:

The server power configuration will be set for gnd redundancy The management switch is 1000 Base-T and the top of rack switches 10Gb What additional component(s) is needed for this configuration?